Runco Q-650i Series, Installation & Operation Manual

Page: 41 / 92

Installation
Q-650i Installation/Operation Manual 27
PRE
L
IMINAR
Y
3.6
Turning on the Power 1. Turn on your source components.
2. Press the ON button on the remote control to turn on the Q-650i. The LED flashes
green to indicate that it is warming up.
3. When the projector is ready for use, the LED turns off.
3.7
Primary Lens
Adjustments The Q-650i gives you a great deal of control over the picture size, position and focus.
Focus and Zoom To focus the projected image, grasp the lens by
the outer ring and rotate it.
To make the picture smaller (zoom out) or larger
(zoom in), move the zoom tab in the appropriate
direction.
Lens Shift To access the lens shift controls, loosen the Phillips screw at the bottom of the decorative
bezel on the front of the projector (see Figure 2-1). Then, remove the bezel.
Vertical Lens S hift: To shift the
projected image vertically, insert
the provided hex wrench into the
vertical lens shift adjuster at the top
of the projector (directly above the
lens). Then, turn the wrench as
shown to shift the lens in the
desired direction.
Horizontal Lens S hift: To shift the
projected image horizontally, insert
the provided hex wrench into the
horizontal lens shift adjuster at the
top of the projector. Then, turn the
wrench as shown to shift the lens in
the desired direction.
When you have finished adjusting the lens position, re-install the front bezel.
Zoom
in
Focu s
Zoom
out
Vertical
Lens Shift
Lens
Horizontal
Lens Shift