Operation
42
Lightstyle™ Series LS-100d Installation/Operation Manual
PRE
L
IMINAR
Y
Contra
s
t:
On your external test pattern source, select a stepped, gray-bar pattern like the
one shown in Figure 4-3.
Figure 4-3. Typical Gray Bar Pattern for Adju
s
ting Contra
s
t
Select Contrast and press
ENTER
. Adjust the contrast to a point just below which the
white rectangle starts to increase in size.
Color
S
aturation:
On your external test pattern source, select a color bar pattern like the
one shown in Figure 4-4.
Figure 4-4. Typical Color Bar Pattern for Adju
s
ting Color
S
aturation and Tint
1. Press the
MENU
button on the remote control or DHD Controller front panel.
2. Select Service from the Main Menu and press
ENTER
.
3. Enter the Service menu passcode.
4. Select Display Device from the Service menu and press
ENTER
.
5. Press
ENTER
again to select Configure.
Brightness and contrast controls are interactive. A change to one
may require a subtle change to the other in order to achieve the
optimum setting.
Note
gray
yellow
cyan
gr
een
magenta
re
d
blue
