Installation
Lightstyle™ Series LS-100d Installation/Operation Manual
31
PRE
L
IMINAR
Y
3.7
Lens Focus
Adjustment
The LS-100d lens focus controls are located
beneath a hinged door on the top of the
projector. To access them, press down on the
door edge closest to the mirror and open the
door.
Use the Coarse Focus Adjust dial to adjust the
focal length in large increments. Use the Fine
Focus Adjust dial to adjust the focal length in
small increments.
3.8
Adjusting the Picture
Orientation
By default, the LS-100d is configured for a “floor/front” installation, in which the projector
is installed upright and in front of the screen. If it is mounted on a ceiling, you must change
the picture orientation. To do this:
1.
On the DHD Controller remote control or front panel, press
MENU
.
2.
Select
S
ervice
from the Main Menu and enter the Service Menu passcode.
3.
Select
Di
s
play Device
from the Service Menu.
4.
Select
Configure
from the Display Device menu, then select
In
s
tallation
.
5.
Select
Orientation
, then choose Ceiling/Front, to match the installation method. Or,
for front-projection installations, use the
Auto
setting to have the projector
automatically determine the orientation (floor or ceiling) using an internal sensor.
The two focus controls are interactive, so you may need to adjust
each one multiple times to produce a fully-focused image.
Press Here
to Open Door
Coarse
Focus Adjust
Fine
Focus Adjust
Note
You must enter a passcode to access the Service menu.
Note
