Ruijie RG-S2900 Series, Installation Manual

Page: 16 / 27

Chapter 3 Product Installation Hardware Manual
3-2
3.2 Confirmation Before Installation
Before installation, please confirm the following points:

Whether sufficient airflow is available for the switch

Whether the requirements of the switch for temperature and humidity are met

Whether power cables are already laid out and whether the current requirements are
met

Whether related network adaption lines are already laid out
3.3
Installing the RG-S2924G/S2927XG/S2951XG Series
3.3.1 Precautions
During installation, note the following points:

Before connecting the power supply, ensure that the external power supply matches the
power requirements of the power module.

Before connecting the power cables, ensure that the power modules are disabled.

Connect the power cables of different colors to the corresponding grounding posts.

Ensure that the connected power cables have sound contact.

Do not place heavy items on the switch.

Reserve a spacing of at least 10 cm around the chassis for good ventilation. Do not
stack the switch.

The switch should be located at places free from large power radio launch pad, radar
launch pad, and high-frequency large-current devices. If necessary, electromagnetic
shielding should be adopted. For example, use interface cables to shield cables.

Interface cables should be laid inside the equipment room. Outdoor cabling is
prohibitted, avoiding damages to device signal interfaces caused by over-voltage or
over-current of lightning.
3.3.2 Mounting the Switch to a Standard 19-inch Rack
The RG-S2924G/S2927XG/S2951XG series switches follow the EIA standard dimensions
and can be installed in 19-inch distribution cabinets. According to the model of the device,
some accessory contains the handles, while others do not contain handles. The installation
of the two is different, the specific description is shown as below:
1. Without handles contained: