·
Hardware Installation and Reference Guide Installing the Access Point
4)
Install the plate cover in the way as shown in Figure 3-4.
Figure 3-4 Install the Plate Cover
After installation, verify that the LED indicator is working properly.
3.5 Connecting Cables
Connect the UTP/STP to the WAN/PoE port on the AP. See Appendix A for the supported wiring for twisted pairs.
Avoid bending the cable in a small radius close to the connector.
Ruijie recommends that you do not use Ethernet cables with protective sleeves as they could make installation of
Ethernet cables more difficult.
3.6 Bundling Cables
Precautions
Make sure the cable bundles are neat and orderly.
Bend twisted pairs naturally or in a large radius close to the connector.
Do not over tighten a cable bundle as it may reduce cable life and performance.
Bundling Steps
1. Bundle the drop UTP/STP cables and route them to the WAN/PoE port.
2.
Attach the cables in the cable tray of the rack.