·
System Debugging
Establishing the Configuration Environment
Establishing the Configuration Environment
Connect the PC to the console port of the switch through the console cable, as shown in 0.
Figure 4-1 Schematic Diagram of the Configuration Environment
Connecting the Console Cable
Connect one end of the DB-9 jack of the console cable to the serial port of the PC.
Connect one end of the console cable RJ45 to the console port of the switch.
Setting Terminal Parameters
Step 1: Start the PC and run the terminal simulation program on the PC, such as Terminal on Windows 3.1 or HyperTerminal on
Windows 95/98/NT/2000/XP.
Step 2: Set terminal parameters. The parameters are as follows: baud rate 9600, data bit 8, parity check none, stop bit 1, and
flow control as none.
1) Choose
Setup
>
Program
>
Attachment
>
Communication
>
Hyper Terminal
.
2) Choose Cancel to display the following page.
Figure 4-2
