Ruida Technology RDC6445GZ, User Manual

Page: 68 / 71

User
’
s Manual of RDC6445GZ Control System
SHENZHEN RUIDA TECHNOLOGY 63
（
2
）
Scanning parameters(Only affect scanning arts)

X-axle Starting Speed

Y-axle Starting Speed

X-axle Acceleration

Y-axle Acceleration
The above four parameters are used to set the starting speed and
acceleration of two axles on the scanning. The higher the two speeds are, the
quicker the scanning is.

Scanning Line-feed Speed
: this parameter is specially used to control
the highest speed at which that the previous line vertically moves to the next line
in the scanning mode. If the space between lines is larger during the scanning or
if the distance of each block is larger during the scanning and deblocking of
figure, it is necessary to position each line or block accurately. In such a case the
speed of scanning line-feed can be set as a lower value.

Scanning Mode : it is divided into general mode and special mode for
option. If special mode is used, the laser power should be increased. The
smaller the speckle percentage is, the more the laser power reduces. The laser
power to set should be larger in order to reach the same scanning depth. The
purpose to select the special mode is to make the laser light at high power and
short time. On the depth scanning the effect that the bottom is flatter is obtained,
but it should be noticeable that if the speckle adjustment is not appropriate, it
can achieve this goal. If the high power remains short, the lighting mode will
influence the life of the laser. The system will default the selection of general
mode.

Speckle Size : When the general mode is selected as the scanning
mode, this parameter will become ineffective; when the special mode is selected,
this parameter will become effective. The controller will control this parameter
among 50%~99%.
The cutting and scanning parameters can’t exceed the limited ones in the
axle parameters. If so, the setting will become ineffective and the system
will automatically cover the parameters with the axle parameters.
（
3
）
Feeding parameters

Before-feeding Time Lag : settable at 0~300s. The lagged time can
facilitate user’s feeding and picking on the feeding device.

After-feeding Time Lag : settable at 0~9.9s. It can facilitate the feeding
device’s delaying in jarring after moving to the correct position and waiting for
the 2
nd work after the feeding axle stands still completely.

Progressive feeding : If this item is enabled, then the dummy array
graph on Y direction will run in the same position, running one line graph, the U
axes moving one time to feed, the moving length of U axes is the interval of the
two lines graph on Y direction.

Progressive feeding repay : Because of the imprecision of U axes’
Prompt