2.5 RMC20 Configuration
The RMC20 can be configured using the DIP switches located at the bottom of the enclosure. The
DIP switches are shown in Figure 2.5.1. Using the switches one can change the operating mode
of the RMC20.
Figure 2.5.1. RMC20 8-Position DIP switch location for configuration
RMC20 DIP Switch Configuration Settings Defined
Position
ON
OFF
1
RS232 to fiber mode
RS485/422 to fiber mode
2
RS232 to RS485/422 conversion mode
Serial (RS232/485/422) to fiber mode
3
Full Duplex Serial (RS232 / RS422)
Half Duplex Serial (RS485)
4
Fiber Repeat ON
Fiber Repeat OFF
5 RESERVED
6
> 57600 baud
7
19200 – 57600 baud
8
4800 – 14400 baud
300 – 2400 baud
13
©
2006 RuggedCom Inc. All rights reserved
Rev100
