RUGGEDCOM RSG2488
User Guide
Chapter 2
Using ROS
Connecting to ROS
25
Using ROS
This chapter describes how to use the ROS interface. It describes the following tasks:
•
Section 2.1, “Connecting to ROS”
•
•
•
Section 2.4, “Using the Web Interface”
•
Section 2.5, “Using the Console Interface”
•
Section 2.6, “Using the Command Line Interface”
•
Section 2.7, “Managing the Flash File System”
•
Section 2.8, “Accessing BIST Mode”
•
Section 2.9, “Accessing the Boot Loader”
Section 2.1
Connecting to ROS
The following describes the various methods for connecting the device:
•
Section 2.1.1, “Connecting to ROS Through a Direct Connection”
•
Section 2.1.2, “Connecting to ROS Through the Network”
Section 2.1.1
Connecting to ROS Through a Direct Connection
ROS can be accessed through a direct serial or Ethernet connection.
Using the RS232 Serial Console Port
To establish a serial connection to the device, do the following:
1. Connect a terminal or a computer running terminal emulation software to the RS232 serial console port on
the device. For more information about the RS232 serial console port, refer to the
RSG2488 Installation
Guide
.
NOTE
The baud rate for the device is printed on the chassis exterior near the RS232 serial console port.
2. Make sure the following settings are configured on the terminal:
• Speed (baud): 57600
