TriggerTrac
Order and Installation Manual:
Installation
TriggerTrac –
Section 3 - Installation
©
Rugged Interactive
20
21
Adjusting the Sensitivity
Notes:
• A small flat-bladed screwdriver is required.
• Do not over tighten, this can damage the sensors, a maximum of a quarter turn in the appropriate
direction should be made each time before retesting.
The sensitivity should be checked and if necessary, adjusted after installation of the targets. Each target has
its own sensor, so each one should be checked.
To adjust the sensitivity, locate the hole on the reverse of the targets. There will be a screw as can be seen
in
Figure 3.4.3
. Using a small flat-bladed screwdriver turn the screw in the desired direction, clockwise to
increase the sensitivity, Anti-clockwise to decrease. Turn a quarter turn before retesting the sensitivity and
repeat if required.
Do not over tighten the screw, this can damage the sensor.
Figure 3.4.3:
Location to adjust the sensitivity
