8
4.3 Installation
Plain Base Installation
Steps of installation
1. Remove the bottom plate of the pan/tilt;
2. Set the corresponding information in accordance with the
schematic drawing of the dip-switch of addresses, protocols and
baud rates;
3. Install the bottom plate of the pan/tilt and take care of the tightness
of waterproof seal ring;
4. If vehicle used, first of all fix the Shock Bracket
on the bottom of the
pan/tilt then fix the whole pan/tilt;
5. If the plain base is used, fix the pan/tilt onto the fixation hole of the
pan/tilt
6
．
Connect the output wires of the socket according to relative colors
on the schematic drawing and do not make wrong connections;
7. For the common pan/tilt, 10-core socket is used as the alarm
