80
Ruckus ICX 7450 Switch Hardware Installation Guide
Part Number: 53-1003899-07
Managing the Ruckus ICX 7450
Replacing an expansion module or service module
•
A new fan assembly (must have the same part number and the same airflow label as the fan assembly being replaced; refer to
on page 77 for the location of the airflow label)
•
A #1 Phillips screwdriver
Installing or replacing the fan assembly
Complete the following steps to install or replace a fan assembly in a Ruckus ICX 7450.
1.
If replacing a fan assembly:
a.
Using a Phillips screwdriver, unscrew the captive screw on the fan assembly.
b.
Remove the fan assembly from the chassis by pulling the handle on the fan assembly out and away from the chassis.
c.
Ensure that the replacement fan assembly has the same part number and airflow label as the fan assembly being replaced.
2.
If installing a new fan assembly into a slot covered with a filler panel:
a.
Using a Phillips screwdriver, unscrew the captive screw on the filler panel.
b.
Remove the filler panel.
3.
Before opening the package that contains the new fan tray, touch the bag to the switch casing to discharge any potential static
electricity. It is recommended that you wear an ESD wrist strap during installation.
4.
Remove the fan tray from the anti-static shielded bag.
5.
Holding the fan tray level, guide it into the carrier rails on each side and gently push it all the way into the slot, ensuring that it
firmly engages with the connector.
6.
When you are sure the fan tray has properly engaged the connector, tighten the captive screw to secure the fan tray in the slot.
NOTE
The fans are controlled automatically by the device.
7.
Verify correct installation by running the
show chassis
command.
Replacing an expansion module or service module
The Ruckus ICX 7450 includes one front-panel slot and two rear-panel slots for media expansion or service modules, including a 4-port
SFP 1 GbE module, a 4-port SFP+ 10 GbE module, a 4-port Copper 10 GbE module, or a 1-port QSFP+ 40 GbE module. The slots in
which these modules can be installed are listed in
on page 18. If not installed, the empty expansion module slot must be covered
using the filler panel.
CAUTION
Do not force the installation. If the fan tray does not slide in easily, ensure that it is correctly oriented before
continuing.
CAUTION
Empty fan and power supply slots must be covered using filler panels.
CAUTION
Disassembling any part of the expansion module or service module voids the warranty and regulatory certifications. There are
no user-serviceable parts inside the expansion module assembly.
