46
Ruckus ICX 7450 Switch Hardware Installation Guide
Part Number: 53-1003899-07
Installing the Ruckus ICX 7450
Installing the Universal Four-Post Rack Kit (XBR-R000296)
Attaching the rear brackets to the rack posts
Complete the following steps to attach the rear brackets to the rack posts.
1.
Attach the right rear bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts, as
shown in
. Use the upper and lower holes in the bracket.
2.
Attach the left rear bracket to the left rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
3.
Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 36
Attaching the rear brackets to the rack posts
Flush-rear (recessed) mounting
The flush-rear (recessed) mounting is similar to the flush-front mounting except that the brackets are reversed on the device.
NOTE
The illustrations in the rack installation procedures show a 1U device, but the instructions are the same for a 2U device. The
illustrations in the rack installation procedures are for reference only and may not show the actual device.
Complete the following tasks to install the device in a four-post rack:
1.
“Attaching the front brackets to the rear of the device”
2.
“Attaching the extensions to the front of the device”
3.
“Installing the device in the rack”
4.
“Attaching the rear brackets to the extensions at the front of the device”
1
Screws, 10-32 x 5/8-in., panhead Phillips
2
Retainer nuts, 10-32
CAUTION
The device must be turned off and disconnected from the fabric during this procedure.
