Ruckus ICX 7450 Switch Hardware Installation Guide
65
Part Number: 53-1003899-07
shows the LEDs on the Ruckus ICX 7450-24P front panel. The up-arrow port status LEDs for the 1 GbE ports correspond to
the upper, odd-numbered ports; the down-arrow port status LEDs correspond to the lower, even-numbered ports.
FIGURE 55
Ruckus ICX 7450-24P front-panel LEDs
NOTE
PoE/PoE+ power is available to ports 1-24. High PoE/PoH is limited to ports 1-8.
The Ruckus ICX 7450-32ZP has the following LEDs on the front panel:
•
Two management port status LEDs (green) for speed and link/activity
•
Two power supply unit (PSU) bicolor status LEDs (green and amber) labeled PSU1 and PSU2
•
One DIAG (diagnostic) bicolor status LED (green and amber)
•
One MS (stacking configuration) bicolor status LED (green and amber)
•
Three MOD (media expansion module) monocolor status LEDs (green)
•
Ten stack ID (stack identifier) monocolor indicator LEDs (green)
•
24 1 GbE port bicolor status LEDs for ports 1-24 (green for 1 GbE and amber for 10/100 Mbps Ethernet) which indicate 1
GbE or 10/100 Mbps Ethernet mode of operation
•
8 2.5 GbE port bicolor status LEDs for ports 25-32 (green for 2.5 GbE and amber for 100/1000 Mbps Ethernet) which
indicate 2.5 GbE, 1 GbE, or 100 Mbps Ethernet mode of operation
•
32 PoE+ port monocolor status LEDs (green for providing power to attached device)
1
Management port speed and link/activity LEDs
6
Ports 1-24 speed and link/activity LEDs
2
PSU1 and PSU2 status LEDs
PSU1 corresponds to the right power supply slot
on the rear panel and PSU2 to the left power
supply slot, as viewed from the rear.
7
PoE power LEDs. The PoE indicator is on if a port is
providing power to the connected device, and off if it
is not supplying power.
3
DIAG (diagnostic) status LED and MS (stacking
configuration) status LED
8
MOD2 1/10 GbE module speed andlink/activity
LEDs
4
MOD (media expansion module) LEDs. Module 2
is located on the right side of the front panel.
Module 3 and 4 are the right and left stacking
modules on the rear panel, as viewed from the rear.
9
MOD2 1/10 GbE power LED
5
Stack ID LEDs
Indicates stack unit identifier (1-12).
