To limit the risk of interference, people with pacemakers must keep the wireless telephone away from their equipment (minimum
distance of15 cm/6 inches).
It is recommended to follow the standard acceptance procedures before using this equipment in human safety critical areas
(hospitals...).
DECT equipment can only be used to establish links between fixed points if these links are temporary.
The conditions of access to a DECT equipment telepoint network shall be stipulated by contract with the operator of the
authorized telepointnetwork concerned.
Switch off the telephone before changing the battery.
You must not switch on or use your telephone near gas or inflammable liquids.
The handset includes magnetic elements that may attract sharp metallic objects.
CAUTION:There is a danger of explosion if the battery is replaced incorrectly. Use only recommended battery RTX816x EX
Battery Pack (3BN67361AA, Cell model no.: LP553450SI - Li-ion 3.7V 1100mAh 4.2Wh).
Be sure to dispose of these products as well as its packing material in an environmentally compatible way.
Electrical equipment, including the battery, should not be disposed of as municipal waste.
These products should be taken to a designated facility where the best available treatment, recovery and recycling techniques are
available.
The mains power socket used must be close to the charger/holder and easily accessible, so that it can be used as an 'on/off'
facility.
Charge the battery for about 6 hours before initial use.
The 8262 DECT Handset desktop Dual charger (3BN67346AA), is dedicated for 8262 EXDECTHandsets(3BN67345AA) and
needs thefollowing Power Supply Units:
PSU Europe (3BN67335AA)
- TenPao (Model S005AYV0500100) – efficiency level VI (rating I/P:AC 100-240V, 0.2A; O/P: DC 5V, 1A).
- Friwo FW7713/XX – efficiency level V (rating I/P:AC 100-240V, 150mA; O/P: DC 5V, 1A).
PSU WW (3BN67336AA)
- TenPao (Model S008ACM0500100 with UK,US,AUS plugs) – efficiency level VI (rating I/P:AC 100-240V, 0.3A; O/P: DC 5V, 1A).
- Friwo FW7712 - efficiency level V (rating I/P:AC 100-240V, 125mA; O/P: DC 5V, 0.9A).
The 8262 DECT Handset Rack Charger (3BN67351AA) will use a dedicated PSU:
-
8262 Dect handset PSU WW for rack charger (3BN67353AA)
- Ten Pao (Model S030ABM0500500) – efficiency level VI (rating I/P: AC 100-240V, 1A; O/P: DC 5V, 5A).
- Friwo FW7540/05 (rating I/P:AC 100-240V, 600mA; O/P: DC 5V, 5A).
With the 8262EX DECT Handset, use only Bluetooth devices marked with the ATEX logo, usable in an ATEX (potentially
explosiveatmosphere) area.
Never charge or install the battery in an ATEX (potentially explosive atmosphere) area.
Regulatory Statements
This equipment uses DECT frequency range that depends on country: 1880 - 1900 Mhz in Europe, 1920 - 1930 MHz in US/Canada,
1910 -1930 MHz in LATAM, 1910 - 1920 MHz in Brazil. The equivalent isotropically radiated power at the antenna is less than 110
mW or 250 mW (itdepends on the country). This equipment offers also Bluetooth® Interface: frequency range 2402-2480 MHz,
Radiated Power 1.72 mW.
EUROPE
This equipment is in compliance with the essential requirements of RED Directive 2014/53/EU (from 13 June 2017), ATEX Directive
2014/34/EU and with ROHS Directive 2011/65/UE.
The Declaration of Conformity may be obtained from: ALE International 32 avenue Kléber – 92700 Colombes, France
USA and Canada
Handset: this device complies with Part 15 of the FCC Rules and with RSS of Industry Canada (FCC ID: T7HCT816X ,IC: 4979B-
CT816X). Thisdevice complies with Part 68 of the FCC Rules and with IC CS-03 Part V of Industry Canada.
Chargers: this device complies with Part 15-B of the FCC Rules and with ICES-003 of Industry Canada.
FCC Caution
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
