7
DE-9S
(Female)
DE-9P
(Male)
6
1
2
1
2
TO ADAM CS, J902
TO: UIO-256, J2
7
2
1
TO: PAP-940,
PAP-951, OR PAP-952
DE-9P
(Male)
6
1
2
TO: PAP-950-50
DE-9P
(Male)
DE-9S
(Female)
DE-9P
(Male)
6
1
2
1
2
TO ADAM CS, J902
TO UIO-256, J2
DE-9P
(Male)
DE-9P
(Male)
6
1
2
1
2
TO XPC-ADAM-MC, J3
TO: UIO-256, J2
7
6
2
1
1
2
TO: PAP-940,
PAP-951, OR PAP-952
TO: PAP-950-50
DE-9P
(Male)
DE-9P
(Male)
DE-9P
(Male)
DE-9P
(Male)
6
1
2
1
2
TO UIO-256, J2
TO XCP-ADAM-MC, J3
Figure 3. ADAM Y-Cable
Figure 4. ADAM CS Y-Cable
Figure 5. ADAM to UIO-256 Cable
Figure 6. ADAM CS to UIO-256 Cable
4.4.3
UIO-256 Frame Interconnections
If more than one UIO-256 frame is used, construct a Y-
cable as shown in Figure 3 or 4 with additional DB-9S
connectors in parallel with the ADAM and ADAM CS
connector. Connect the addition connectors to the J2
connector on each additional UIO-256.
4.4.4
UIO-256 to Zeus System
Zeus is compatible only with UIO-256 firmware Version
2 or later, and it supports only multi-drop connection.
Use the DIP switch information for ADAM and ADAM
CS. Make sure DIP switch 2 is set for “multi-drop”
connection. Also, Zeus is limited to 64 GPI inputs and
64 GPI outputs. Since each UIO-256 has 16 of each,
this means that you can only use up to four UIO-256
frames with Zeus. When setting frame numbers, only
frame numbers 1 through 4 are allowed.
Treat the Zeus the same as an ADAM for wiring pur-
poses, except connect to J26 on the Zeus back panel
instead of J3 of the XCP-ADAM -MC breakout panel.
4.5
GPI Output and Input Connections
Use 50-pin Telco cables to connect from the GPI input
and output connectors to each UIO-256 to punch blocks
or similar breakout devices. Pin-outs for the connectors
and punch blocks are summarized in Tables 2 and 3.
4.6
Power Connection
Plug in the supplied power cord for each UIO-256. The
UIO-256 does not have a power ON/OFF switch or
indicator, so it may be convenient to use a switched
power outlet.
