RTS PAM-16, User Instructions

Page: 29 / 34

27
Service Menu
SERVICE, MODE
The Mode menu determines how the keypanel handles active keys.
There are three (3) modes of operation:
Many – MANY mode gives preference to many keys being on at once. Tap any key to latch it in the ON position. The
green LED is lit while the key is ON. You can tap several keys to latch them ON.
In MANY mode, if a key is held down for 2–3 seconds, this key becomes active and turns OFF any latched keys currently
latched ON. Upon release of the held key, the previous latched ON key returns to the ON state.
Monitor – MONITOR mode allows the user to listen (monitor) to any crosspoint on the PAM-16 when the key is active.
One – ONE mode gives preference to a single active key. Tap a key to turn it ON. The green LED lights. When you tap
another key, the first key turns OFF and the second key turns ON.
In ONE mode, if a key is held down for 2–3 seconds, this key latches ON and does not turn OFF when the next key press
occurs. It remains latched ON until it is pressed again, returning it to normal ONE mode operation.
SERVICE, RESET
RESET restores all items on the SERVICE menu (except MOD ASGN) to the factory default settings. RESET also resets the
VOLUME to minimum at power-up. RESET does not affect any of the key assignments you create using KEY ASGN menu:
these assignments are saved at the intercom system and not the keypanel.
1.
After you select RESET , the displays show asterisks for a few moments.
SET ADDR displays as if the keypanel is being powered up for the first time.
2.
You must reenter the correct keypanel address. “SERVICE, SET ADDR” on page 27.
SERVICE, SET ADDR
SET ADDR must be used during installation or whenever the keypanel is reset or moved to a new port.
Determine the Keypanel Address, CS9XXX Intercoms
For intercom port numbers ending in 1 through 9, the keypanel address is the last digit of the port number. If the last digit of
the port number is 0, use 10 as the keypanel address.
Determine the Keypanel Address, ADAM and ADAM CS Intercoms
See, Table 1 on page 11.
Determine the Keypanel Address, Zeus Intercom Systems
The address is the number (1–8) printed next to the connector on the back panel of the Zeus Frame. This number repeats for
each group of eight (8) connectors. The intercom system is able to distinguish between two (2) keypanels set to the same
address by the group where each one is connected.
To set the keypanel address , do the following:
Keys 53-56 MOD 15
Keys 57-60 MOD 16
TABLE 4.
The relationship between setup pages, key numbers and MOD numbers.
Setup Page 1