Проверил: Р.Ч./24.03.2015г
- 5 -
Fort he working of thin metal such as sheet metal, switch off the pendulum action.
In materials such as softwood and cutting in the direction of the grain, the maximum
pendulum action can be used.
OPERATING INFORMATION
CUTTING
Do not depress too much to worpiece for avoiding damaging and heating of blade. For avoiding vibration
and cutting beter, put the workpiece to a firm plate.
CUTTING ANGLE ADJUSTMENT
For cutting of mitre angles loosen the 2 set screws till the saw shoe to the required mitre angle. Mitre
angle to the left/right is maximum 45°. After adjusting desired angle, tighten the set screws firmly.
Adjustable angles on jigsaw are 0°, 15°, 30°, 45°.
PLUNGE SAWING
Only soft materials such as wood, aerated concrete, plaster board aerated concrete, plaster board, etc. may
be worked with plunge method.
Cut-outs in wood are possible without predrilling by piercing with the running machine. This is requires a
certain amount of practice, however, and is possible only wit short saw blades.
Place the front edge of the base plate on the workpiece and switch on. Press the machine firmly against
the workpiece and plunge the saw blade slowly into the workpiece.
After reaching the required cutting depth, bring the machine again to the normal working position so that
the complete surface of the base plate rests on the workpiece and continue to saw along the cutting line.
After completing the cut , switch off the machine first and then pull it out of the cut.
MAINTENANCE AND CLEANING
Before any work on the machine itself, pull the mains plug.
Guide roller should occasionally be checked for wear and lubricated with a drop of oil. If it is worn ,
it must be changed. For safe and proper working , always keep the machine and the ventilation slots
clean.
If the machine should happen to fail despite the care taken in manufacture and testing, repair should be
carried out by an authorized customer services agent for
RTRMAX power tools
.
Old electrical devices should not be treated as ordinary waste. Disposal or
recycling of parts of them should be in places with the appropriate
equipment. For information on collection and use of old electrical equipment,
contact your local authorities or dealer.
