Проверил: Р.Ч./24.03.2015г
Avoid accidental starting. Ensure the switch is in the off position before plugging in.
Carry power tools with your finger on the switch or plugging in power tools that have
the switch on invites accidents.
Remove any adjusting key or wrench before turning the power tool on. A wrench or a
key left attached to a rotating part of the power tool may result in personal injury.
Avoid to stop very often during the working , because it damages the battery.
Place the battery only 230V AC. Aküyü sadece 230V AC’ ye bağlayın.
Charge the screwing/drilling battery by only given available charger. Vidalama /
Delme aküsünü tahsis edilen şarj aleti ile doldurun.
Battery and screwing/drilling part must be safe from humidity.
The tool mustn’t be used, when the battery charging.
Don’t allow the batteries over 50° temperature because of damaging batteries.
Warning: Don’t make short circuit Battery connections and charger.
Carefully check the anode and cathode when charging.
Do not throw the batteries to fire.
KEYLESS CHUCK
The keyless chuck fitted to your cordless drill has a capacity of 10mm(3/8’’) and will accept
any accessory with a shank diameter not exceeding 10mm. All model have variable speed
control and forward and reverse making the drill ideal for tightening and loosening screws
and other fixings.
CHARGING THE BATTERY
Before use, charge the battery for at least 1 hour.
Remove the battery from the drill by pressing the battery release
button on each side of the battery pack.
Push the battery into the charging base. The battery will only fit into
the base in one direction. DO NOT FORCE the battery into the
base.
Plug the adaptor into a suitable mains supply.
The battery will be fully charged in 1hour.
Do not take out the battery from the charging base during the
charging process till the red light turns to green!
USING THE DRILL
Push the battery into the bottom of the drill body until it clicks into
position.
The drill is now ready to use.
