21
13.0 MAINTENANCE
Time schedule
Check point/lubricating
point
Method
Before
each
use
Check for loose bolts/nuts.
Tighten the loose bolts/nuts
with the correct torque.
Presence and legibility of safety
stickers (
Figure 5
)
Replace if damaged or
missing.
After
each
use
Clean the machine
Clean the machine with
compressed air. Don’t use
water.
After
first
20 operating hours
(new or repaired)
Grease the wheel bearings of
the rear wheels.
Use EP 2 lubricating
grease.
Check for loose bolts/nuts.
Tighten the loose bolts/nuts
with the correct torque.
Grease the drive chains.
Use a chain spray.
After
every
100 operating
hours.
Check for loose bolts/nuts.
Tighten the loose bolts/nuts
with the correct torque.
Grease the drive chains.
Use a chain spray.
Check the tension of the drive
chains.
Tension the tensioners of
the drive chains.
Check the seeding elements for
dirt/damage.
Clean the seeding
elements or replace if
necessary.
Check the seeding element
valve opening.
Adjust the seeding element
valve if necessary.
Check the seed quantity.
Carry out a spreading test.
Check the seeding
pipes/funnels.
Clean if necessary.
Grease the wheel bearings of
the rear wheels.
Use EP 2 lubricating
grease.
Make sure there is enough
grease in the gearbox
Fill the gearbox with 2,8 ltr
EP 0 Grease
Clean the hopper
Clean with compressor air,
don’t use water.
Tabel 3
