T1 Universal System Controller
8
DOCKING STATION REFERENCE
1-3/8 in.
(35mm)
Power Jack
Wire Guide
Wall Mount
Holes
Back
Charge LED
Charge Contacts
Front
Introduction
5
BATTERY AND DOCKING STATION
The
T1
uses a Lithium-Ion rechargeable battery. This battery does
not exhibit any type of “Memory Effect” from being charged too
often. Since the
T1
can safely be charged after each use, a docking
station is included for convenience. If left out of the docking
station, the
T1
will remain in sleep mode for 1 – 2 months before
shutting down. At that point the battery must be recharged.
If the
T1
battery capacity is reduced to approximately one hour of
remaining run-time, the Status LED will illuminate red while the
unit is powered-up.
The
T1
Docking Station can be placed on a flat surface such as a
shelf or table, or it can be mounted to a wall using the mounting
holes on the back of the unit.
The docking station LED illuminates to indicate a charge in
progress. The LED will turn off when the battery in the unit is
fully charged.
A fully discharged battery will take approximately 2-4 hours to
completely re-charge.
The
T1
can remain in the docking station indefinitely without
damage to the battery.
GETTING STARTED
Start by inserting the battery connector into the mating plug on
the
T1
. Make sure the connector is oriented properly before
attempting to insert it.
