T1 Universal System Controller
10
After the keycap is cut-out from one of the sets, simply press it
over an empty keycap button. Make sure to press down firmly on
the keycap until it is fully seated.
Note:
The keycaps can be permanently secured by using an
adhesive that bonds to silicon rubber. The following instant
adhesive glue works well and is readily available:
Silicon Adhesive
: Loctite
PRISM
®
401 (p/n 40104)
U.S. Resellers
:
Contact East: # 173-606
McMaster-Carr: # 74765A63
Grainger: # 3KE58
Follow these steps to apply the Loctite #401 adhesive:
1.
Apply a thin layer of the adhesive to the entire top
surface of the desired keycap button.
2.
Press the desired keycap over the button.
3.
Press down firmly on the keycap for 15 seconds.
Repeat these steps for each keycap on the
T1
.
PROGRAMMING THE T1
The
T1
is programmed using RTI’s
TheaterTouch Designer
software.
RTI dealers can download the software for free at:
www.rticorp.com/dealers
A PC running Windows
®
98SE or higher with a USB port is
required. The required USB cable is included with the RTI
IR-PRO
dealer kit.
Note:
The
T1
will not operate normally while connected to a
PC’s USB port. Make sure you disconnect it from the PC to
navigate pages or transmit commands. In addition, the
T1
will not be able to sync with a PC’s USB port while it is
transmitting a command or running a macro.
3
Chapter 2. Introduction
FEATURES
The
T1
provides superior quality and reliability as well as these
specific features:
!
A replacement for all of the remote controls in a home
theater. The
T1
can reproduce all of the commands of almost
any other infrared remote control.
!
Customizable button keycap labels for eight source buttons
and four general purpose buttons. The
T1
button labels can
be changed to match each installation.
!
34 pre-defined keypad buttons that allow easy access to
frequently used functions.
!
A bright blue backlight. The keypad is easy to read in any
lighting condition.
!
A light-weight, low-profile Lithium-Ion rechargeable battery
pack. The
T1
can run continuously for several hours between
charges. Because the remote is normally used only a few
minutes per session, the unit typically will run for a week or
more between charges. A built-in low battery indicator
warns you when it’s time to recharge the battery.
!
A macro function. This feature allows the
T1
to perform a
series of commands by pressing a single button. For
example, you can create a macro called “Movie” that turns
on the TV, sets the correct input, turns on the DVD player,
dims the lights, and starts playing a movie.
!
Both infrared (IR) and radio frequency (RF) output options.
You can even use both options on the same unit.
!
A built in motion sensor can automatically turn the unit on
when it is picked up.
