![background image](http://html1.mh-extra.com/html/rti/black-piranha/black-piranha_quick-manual_1497728003.webp)
Quick Guide
9604554-01 Quick Guide Black Piranha on Pristina 2017.3D.docx
3(4)
v.2017.3D
The image to the right shows the template for the HVL
measurement on Small Focus.
The template supports one shot HVL as well as traditional method
by adding layers of Aluminum.
Follow the job card instructions for the measurement. No settings
in Ocean should have to be made.
Notice:
The
Position check may be suggested (yellow bar besides the green
“ready” box)
. Is so, abort by clicking in the yellow field as described
above.
When ready for next test, just press the
New Quick Check
button.
You shall now be back to the selection screen as described under (i)
above, or exit Ocean.
Tube Voltage
–
ELE 010
The template is built for measurement without compression
paddle. The compression paddle may be used. Then you need to go
Meter Settings¸
and change the setting to
Use
compression paddle.
Follow the GE job card instructions for the measurement.
Notice:
The
Position check may be suggested. If so, abort by clicking in the
anywhere in the yellow area as described above.
When ready for next test, just press the
New Quick Check
button.
You shall now be back to the selection screen as described under (i)
above, or exit Ocean.
3.
Measure using GE Mammo Quick Check
Setup
n.
Place the Black Piranha in the holder as shown in image (right) with the left pin
inside the tripod mounting hole.
The Black Piranha will only fit in one way.
o.
Slide the holder into the GE dosimeter support.
p.
The Black Piranha can be left in this positon for all measurements described below.
q.
Follow the job card instructions when it comes to image detector protection, IQST
phantom set-up, compression paddle set-
up, etc…
Measure
When starting Ocean the measure guide as shown in image (right) should appear. If not, the
option “Auto
-
start Quick Check” is deactivated. This function can be activated under Options.
r.
Select
Mammo quick check.
s.
A set-up instruction (hint) will pop-up.
t.
Press the right arrow key in the lower left corner to get to the measure screen.