BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS.
P.
4
RTA-
3992D
P.
4
❶
Do a quick inventory to
make sure the package
contains all the parts and
hardware listed in the
assembly instructions.
❷
Missing, damaged and
defective parts can be
replaced at no cost to you.
Please refer to the CONTACT
card included with the
product.
❸
The replacement parts service
is limited to the continental United
States. If you reside in Hawaii,
Puerto Rico, U.S. Dependencies
or other countries, please contact
the supplier from where the unit
was purchased.
❹
If during assembly you
find an issue or need
clarification, please contact
our Customer Service for
assistance. Please refer to the
CONTACT card included with
the product.
❺
On each step read the
instructions and analyze the
illustrations thoroughly
before proceeding to do the
assembly.
❽
Do not overtighten
or force the screws as
they might break, strip,
damage the threads of
the holes or get stuck
inside the part.
❻
Make sure you understand
which hardware will be used
on each step. Using the wrong
size of screw, bolt or pin might
strip the threads or cause
damage to the part in which it
is being used.
❼
To avoid misalignments,
always leave the screws
loose and tighten them until
all pieces are positioned
correctly.
❾
Sometimes the laminate might cover partially or entirely
the hole on a panel. If there is no visible hole for the screw,
pass and press the tip of your finger over the area where
the hole should be located to feel the indentation, and once
found, carefully pierce the laminate to reveal the hole
underneath.
❿
If the hole seems too small for the screw, first make
sure you are using the correct size of screw and that it’s
been installed in the correct hole. If the hole still appears to
be too small, carefully pierce the laminate to reveal the
hole’s actual size.
