106
Effects and 31-band GEQ
Effects and 31-band GEQ
The GEQ EDIT popup is used to edit the 31-band GEQ.
31-band GEQ
ffig.ScrGEQEdit_Guide.eps
1.
Analyzer display
This shows a 31-band realtime analyzer, and the source level.
2.
SRC (source)
This selects the source for the analyzer.
3.
WINDOW
Here you can move the analyzer’s vertical display region in a
range of 0 dB – -48 dB.
4.
AVG (average)
Here you can select the averaging method for the analyzer.
5.
AVG TIMES (average time)
This specifies the value (1–128) by which the analyzer’s display
will be averaged.
6.
PEAK HOLD button
When this is on, the analyzer’s peaks will be held.
The Hold time is specified by the HOLD TIME setting of the
METER SETUP popup.
7.
IN meter
This indicates the level of the signal input to the GEQ.
8.
OUT meter
This indicates the level of the signal output from the GEQ.
9.
LINK button
This links adjacent odd-numbered and even-numbered GEQ
units. If units are linked, their GEQ settings will be identical.
10.
BYP button (bypass)
This bypasses the GEQ. If this is on, the GEQ will be bypassed,
and the input signal will be output without change.
You can also make the setting for switching bypass on or off
from a USER button (p. 154).
11.
GEQ faders
For each frequency band, these adjust the amount of boost or
cut in a range of -15.0 dB – +15.0 dB.
The value of the fader you operate is shown in the sub-display
area.
Noise may occur when you operate the GEQ faders, but this is
not a malfunction.
12.
EQ MODE select buttons
Here you can select either 31-band GEQ or 8-band parametric
EQ.
13.
EQ ATT (EQ attenuator)
This adjusts the input level to the 31-band GEQ or 8-band
parametric EQ in a range of -42.0 dB – +15.0 dB.
In the GEQ EDIT popup (31-band GEQ), the function buttons
perform the following operations.
Editing the 31-band GEQ
parameters
GEQ EDIT popup
AVG value
Explanation
OFF
Averaging will not be performed.
NRM
Averages evenly by the number specified in
AVG TIMES.
EXP
Recent times will be weighted more heavily in
the calculation.
1
1
11
11
2
3
4
5
6
7
8
9
10
12
13
Choice
Explanation
31-BAND GEQ
Use the EQ as a 31-band GEQ.
8-BAND PEQ
Use the EQ as an 8-band parametric EQ.
[F4 (FLAT)]
Sets the 31-band GEQ to a
flat response.
[F5 (LIBRARY)]
Accesses the GEQ LIBRARY
popup.
[F6 (GEQ ON FADER)]
Performs GEQ operations
using the faders on the top
panel.
[F7 (FADER RANGE)]
Switches the band for per-
forming operations using
the faders on the top panel.
[F8 (CLOSE)]
Closes the popup.
M-380_e1.book 106 ページ 2010年6月30日 水曜日 午前10時31分