29
INSTALLATION— Continued
Utilizing the RSL Speedwoofer’s Built-in High Pass Filters — Continued
1. You’ll need one pair of RCA cables that will reach from your preamplifier to
your RSL Speedwoofer
tm
10 and another pair that can reach from your Speed-
woofer back to your power amplifier.
2. Connect an RCA cable to the right and left output terminals on your pream-
plifier.
3. Next, connect each cable to the right and left “low level in” input terminals on
your RSL Speedwoofer (located on the back of the enclosure). Don’t use the
LFE input.
4. Now, use the two remaining RCA cables and plug one end of each into the
right and left “low level out” terminals of the RSL Speedwoofer
tm
10.
5. Run these cables to your power amplifier and connect them to the right and
left input terminals.
6. Now, connect the both speaker wires to the right and left “speaker outputs”
on your power amplifier. Remember to double check the polarity.
Utilizing the RSL Speedwoofer’s Built-in High Pass Filters
Summary of Contents for CG24 Monitor
Page 2: ......