11
OPERATING YOUR FAN
Turn the RF wall control power on and check the operation of your fan. The RF wall control
controls the fan speed as follows:
FAN
OFF
FAN
OFF
Press the FAN OFF button to turn fan off.
Hold this button to get light brighter.
Code Learning Mode:
The wall transmitter has been pre-paired with the fan for your convenience, however shall you
ever need to replace the wall transmitter, follow these simple steps:
1. Within 30 seconds after the receiver is powered ON (connected), press the “FAN OFF”
button on the transmitter for 3~4 seconds.
2. The digital paring is complete, you can operate the fan normally.
The buttons on the wall transmitter control the fan speed and light as follows.
Forward/ Reverse-
Press this button to get desired airflow direction.
It will take a few seconds for fan to slow down and
change rotation direction.
Press this button to turn the light on and off.
Control light level down. Hold this button to dim light.
Power Slide Switch is to turn power ON or OFF.
Fan Speed
1- Highest Speed
2- High Speed
3- Med Speed
4- Low Speed
5- Lowest Speed
NOTE:
Dimming function is not available if light kit is not dimmable. The remote controller
used on DC ceiling fan model# 1070W and #1080W are not capable of dimming
function, when use this remote transmitter with light kit installed to these two models,
pressing or button has no effect.
Wall Transmitter Operation
Summary of Contents for 1070W
Page 16: ...RP 100919...
