INSTALLATION
Transmitter Installation
A
screw
B
metallic washer
C
electronic unit
D
valve
E
rubber washer
F
metallic washer
G
collar nut
H
valve cap
I
installation pin
1) Take out of the product from the package, and the transmitter is a whole
unit. It's needed to unscrew the valve cap (H) and the collar nut (G),
take off the metallic washer (F), and loose the screw (A).
2) Put the electronic unit (C) and valve (D) through the valve hole of the
hub. Then put the metallic washer (F) on the valve, tighten the collar
nut (G). (Fig-1)
INSTALLATION
14
15
3) Put the installation pin (I) into the radial boring of the valve and
tighten collar nut (4 0.5 Nm torque.) (Fig-2)
4) Press the electronic unit lightly into the deep well of the hub in order
to let the electronic unit lie flat in the drop center. Apply the thread
glue on screw (A) then tighten it the with 4 0.5 Nm torque.(Fig-3)
5) Now the electronic unit had tightly leaned against the valve. (Fig-4)
6) Tighten the valve cap and complete the installation. (Fig-5)
7) Install tire onto the wheel. Attention must be paid to ensure that the
tire bead does not press against the wheel electronic unit! Inflate the
tire and do the balance. Make sure there is no air leak.
8) Do the same thing as above to the other tires.
±
±