9
Front Fender Installation
Use Screw Driver and Wrench:
1. Front fender attaching hardware
has been pre-assembled onto the
fork. Remove the Bolt (8) and
Washer (9) and Nut (10) from the
fork crown.
2. Remove lower mounting Bolts (7)
and Washers (6) from the dropout
before starting (
fi g 01
).
fig 01
7
6
8
9
10
3. Place the Fender (3) in the fork
with the longer fork mounting tab
(A) on the rear side of the fork (
fi g
02
).
4. Insert the Bolt (8) through the
Washer (9) and Fender tabs and
fork mounting hole.
5. Install Washer (9) and Nut (10)
onto Bolt (8) and tighten securely.
fig 01
fig 02
8
9
A
10
9
3
6. Line up the lower Fender Braces
(B) with the Fork Mounting Tabs
(C) (
fi g 03
).
7. Insert each lower mounting Bolt
(7) and Washer (6) into the Fork
Mounting Tabs (C) and tighten
securely.
fig 03
7
6
B
C
