Care
Clean only with water or soapy water, never with aggressive cleaning agents. The most important factor in increasing the
life and the appearance of the foil material is the observation of the correct water composition.
The filtration pump included in the supply of your pool is intended to remove dirt and other small particles from your pool
water. However, it is VERY IMPORTANT THAT YOU STRICTLY ADHERE TO THE SCHEDULE FOR THE CHEMICAL
TREATMENT to ensure that the pool water is clear, free from algae, and free from harmful bacteria. Please contact your
local dealer for pool accessories to receive information concerning the secure and effective use of chlorine, Aquashock,
algaecides, or other such chemicals.
The appropriate technology for the water test is important. Please read and comply with the written instructions of the
chemicals producer (available from specialist retailers). Make sure that the foil material never gets in contact with
chlorine before it is completely dissolved. This means that chlorine in granular form or in tablet form must be dissolved in
a bucket of water first. Liquid chlorine should be poured into the pool at different points and then must be immediately and
thoroughly mixed with the pool water.
Repair
Your pool will be delivered with a small repair kit to patch small holes. Use might lead to holes in your pool from time to
time. Most of the leaks can be repaired in only a few minutes and, over night, the pool will be ready for use again.
NOTE: Repairs should always be carried out with the pool in an empty (air and water) condition.
Air leaks:
In the case that your pool seems to be a bit “soft”, this is not always caused by a leak because every variation in
temperature can result in a change of pressure of 0.003 bar per degree Celsius. In the case that the pool has been
initially inflated late in the day, this air eventually cools down during the night.
The cooler air exerts less pressure on the skin of the pool so that it seems to be "soft" the next morning.
However, if there were no variations in temperature you first have to determine where exactly the air is escaping. Please
follow these instructions:
Small repairs:
Deflate the air from your pool. Thoroughly clean the area to be repaired (for this purpose you can use a vinyl cleaner) and
dry it. In the case of a small hole / tear (less than 1-2 mm) apply a small drop of adhesive. Let it dry for 12 hours.
Patching:
Leaks which are bigger than 2 mm can be repaired with patches.
1. Thoroughly clean the area around the leak to remove all dirt or grease.
2. Cut out a piece of the repair material, big enough so that its edges go approximately 1.5 cm beyond the damaged
area. Use a pen to apply the outline of the patch.
3. Apply the adhesive at the bottom of the area to be repaired and around this area. thinly but completely, spread the
adhesive on the affected area. Let the adhesive dry for 2-4 minutes until it seems to be sticky.
20/21
Summary of Contents for 10289
Page 22: ......
