![background image](http://html.mh-extra.com/html/royal/r-3500tv/r-3500tv_installers-manual_1493988026.webp)
26
Step 12
Before Lighting
the Fireplace
Before
lighting the fireplace, be sure to do the following:
Remove all paperwork and documents from
underneath the fireplace.
Review safety warnings and cautions
Read the
Safety and Warning Information
section
at the beginning of this
Installers Guide
.
Double-check for gas leaks
Before lighting the fireplace, double-check the unit
for possible gas leaks.
Double-check vent terminations and front
grilles for obstructions.
Before lighting the fireplace, double-check the unit
for possible obstructions that could be blocking the
vent terminations or the front grilles.
Double-check for faulty components
Any component that is found to be faulty
MUST BE
replaced with an approved component. Tampering
with the fireplace components is
DANGEROUS
and voids all warranties.
A small amount of air will be in the gas supply lines.
When first lighting the fireplace, it will take a few
minutes for the lines to purge themselves of this air.
Once the purging is complete, the fireplace will light
and will operate normally.
NOTE:
The fireplace should be run for 8 hours on the
initial start-up. This will help to cure the chemicals used
in the paint and logs.
Subsequent lightings of the fireplace will not require this
purging of air from the gas supply lines,
unless
the gas
valve has been turned to the OFF position
, in which
case the air would have to be purged.
Step 13
Lighting the
Fireplace
Youve reviewed all safety warnings, youve checked
the fireplace for gas leaks, you know the vent system
is unobstructed, and youve checked for faulty
components. Now youre ready to light the fireplace.
WARNING
PLEASE REFER TO THE USERS
MANUAL FOR ALL CAUTIONS, SAFETY,
AND WARNING INFORMATION
PERTAINING TO THE LIGHTING AND
OPERATION OF THE FIREPLACE.
After the
Installation
LEAVE THIS INSTALLATION MANUAL
WITH THE APPLIANCE FOR FUTURE
REFERENCE.
!
!