REAR WHEEL DRILLING INSTRUCTIONS
STEP 3
•
Remove existing rear leg glides.
•
Place the chair onto a flat surface. Measure up 1 1/8” from the
floor and place a mark on the inside of each rear leg. This marks the
center of the hole to which the rear wheels will be attached.
•
Drill a hole through each rear chair leg, using the ¼” drill bit. Make
sure that the holes are drilled at 90 degrees to the positioning of the
chair and inline with the hole on the opposite leg.
REAR WHEEL ASSEMBLY - PART 2
STEP 4
•
Insert the Bolt through the hole in the leg. Thread the Jam Nut (Inner)
completely & tighten securely - use the Allen Key (#12) to secure the Bolt
while tightening the Jam Nut (Inner) with a wrench.
•
Place the remainder of the hardware components onto the Bolt in the
order as shown (Pausing at the Lock Nut stage). Use the Allen Key (#12) to
secure the Bolt while tightening the Lock Nut with a wrench.
NOTE: The rear wheel requires tension in order for the chair to perform as
designed. The rear wheel shall “TURN” when pressure is applied (It should NOT
spin). Adjust as necessary.
•
Once the appropriate tension has been set with the Lock Nut - thread the
Jam Nut (Outer) onto the Bolt and secure it up against the Lock Nut tightly.
To do this, hold the Lock Nut in place (Do not re-tighten Lock Nut) with one
wrench and tighten the Jam Nut (Outer) using the second wrench (See
Diagram A).
•
Use a hacksaw to cut off excess Bolt. Attach plastic cap.
Required Items:
3” Wheels (#4)
X2
Bolt Wheel Assembly - Rear Wheel (#15)
X2
REAR LEGS
(BACK VIEW)
LEVEL FLOOR
1
1/8
”
1
1/8
”
REAR LEGS
FRONT LEGS
FRONT LEGS
REAR LEGS
(BACK VIEW)
REAR LEGS
REAR LEGS
(BACK VIEW)
Jam Nut (Inner)
Large Flat Washer
Axle
Small Flat Washers
Bellville Washer
Jam Nut (Outer)
Lock Nut
Bolt
Hold
(TOP VIEW)
(TOP VIEW)
RIGHT
REAR LEG
(Back View)
Front View
Diagram A
