STEP 1
INSTALL FRONT LEG STOPPER GLIDES
STEP 2
Required Items:
3/4” Flat Head Wood Screw (#8)
X2
Quickclick Base -Front Glide (#9)
X2
Quickclick 30mm Stopper Glide (#10)
X2
•
Remove existing glide from the front leg of the chair. Drill a small pilot
hole, up from the bottom of the chair, into the center of the chair leg using
the 1/16” drill bit.
•
Secure the Quickclick Base (#9) properly ensuring that the head of the
3/4” Flat Head Screw (#8) is fully depressed.
•
Do the same to both front legs. Insert the Quickclick Stopper Glide (#10).
FRONT LEG
10
8
9
NOTE: Failure to insert
the stopper glide will
cause potential
damage to the floor.
PLEASE VERIFY THAT YOUR CHAIR MEETS ALL THE REQUIREMENTS AS STATED IN THE
PACKAGING (’
CAN THE ROYAL EZ BE ATTACHED TO MY CHAIR’)
BEFORE STARTING.
Front chair leg
when complete.
CARE SHOULD ALWAYS BE TAKEN WHEN USING POWER TOOLS AND SHOULD ONLY BE HANDLED BY
EXPERIENCED USERS. PLEASE REMEMBER TO ALWAYS WEAR SAFETY GLASSES.
ROYAL EZ ASSEMBLY
Required Items:
Right Arm (#1)
Left Arm (#2)
Wheel Link Assembly (#3R / #3L)
Quickclick Holder 40mm (#5)
1” Flat Head Screw (#11)
Hinge Pins (#14)
X2
Cotter Pins (#18)
X2
Quickclick 40mm White Glide (#6)
Quickclick 40mm Felt Glide (#7)
•
Attach the Right Arm (#1) the Left Arm (#2) and the
Quickclick Base 40mm (#5) together using the 1” Flat
Head Screw (#11).
•
Attach the Wheel Link Assembly (#3R / #3L) to the
Arms (#1 & #2) using the Hinge Pins (#14). Secure in
place with the Cotter Pin (#18). Please ensure that the
button head bolts are towards the outside of the frame.
•
Insert Glides:
For hard floor surfaces insert Quickclick
40mm Felt Glide (#7).
•
For carpeted floor surfaces insert Quickclick 40mm
White Glide (#6).
11
OR
5
6
7
3L
14
18
1
2
14
18
3R
