32
4 Maintenance
4.4
Changing the motor
protection filter
1.
Switch off the vacuum cleaner and remove the dust filter
bag as described in
Z
Chapter 4.1, "Changing the dust
filter bag"
, steps 1 thru 4.
2.
Remove the filter holder with motor protection filter
(Fig. 22/1). Your first flip the filter holder forwards and
then pull the filter up and out.
3.
Remove the motor protection filter (Fig. 23/1) from the
filter holder (Fig. 23/2) over a dustbin.
4.
Clean the filter holder.
5.
If the new motor protection filter is too large, lay the the
old filter onto the new filter mat. Mark the contours and
cut the new filter down to size with a pair of scissors.
6.
Insert the new motor protection filter into the filter
holder.
7.
Insert the filter holder with the new filter into its bracket
from above and push it down until it audibly locks into
place.
8.
Replace the dust filter bag and close the dust
compartment cover. The cover clicks into place audibly.
4.5
Cleaning the housing
Clean the outside of the housing using a slightly damp
cloth only.
Fig.22
Fig.23
1
2
Fig.24
WARNING:
Always switch off the appliance and disconnect it from
the mains before cleaning it
Z
Chapter 3.3, "Switching off
and retracting power cord"
.
ATTENTION:
Do not use cleaning or scouring agents or alcohol, as
these might damage the appliance.
M7030_gb.book Seite 32 Donnerstag, 3. Januar 2008 3:50 15
