27
3 Operation
GB
3
Operation
3.1
Vacuum cleaning
.
1.
Attach the desired nozzle or pull out the
Z
Chapter 2.2,
"Assembly"
power
Z
Chapter 2.3, "Using further
nozzles (accessories)"
.
2.
cord until the yellow marking is visible (Fig. 10/1)
3.
Switch on the vacuum cleaner with the on/off switch
(Fig. 11/1).
WARNING:
Check the vacuum cleaner and the power cord each time
before using it. A damaged appliance must not be used.
There is danger of injury.
ATTENTION:
Only use the vacuum cleaner with all filters intact, in dry
condition and correctly placed. Make sure that the
openings of the vacuum cleaner are not clogged.or
obstructed. Otherwise the vacuum cleaner might be
damaged.
NOTE:
Your vacuum cleaner is equipped with a safety switch to
prevent overheating. It automatically cuts off the power
supply if the motor is overheated. In this case switch off
the vacuumcleaner and disconnect it from the mains.
Remove the cause of the overheating. Wait for about 45
minutes. After it has cooled off, you may use the vacuum
cleaner again.
WARNING:
If the red marking shows (Fig. 10/2) retract the cord by
pressing the retract buttonto pull in the cable (Fig. 11/2)
up to the yellow mark again. Otherwise the cord might
break. There is danger of an electric shock.
Fig. 10
Fig.11
M7030_gb.book Seite 27 Donnerstag, 3. Januar 2008 3:50 15
