4.1 Adjusting Take-Up Shaft Speed
1. Main rollers and Take-Up Shaft speed is not synchronized.
1. Take out the Take-Up Shaft Cover by loosing three screws. Figure 1
2. Use a 11/16" (17mm) wrench to loosen (increases speed) or tighten (reduces speed) the bolt. Figure 2
4.2 Adjusting Front Roller
7.2)
RSC
30 ~ 36
37 ~ 42
on the gauge
when the machine is running, check that
the top and the bottom films are fed in
without any wrinkles.
4. Adjustments
with different thickness of substrates.
3. Laminating Test –
Laminate samples
1.5mil & 5mil films.
4. Check above steps 2 through 3
with
5 spots as shown on Figure B &C:
Front roller should read between 2-3
2. Checking for over all tension
–
CAUSES:
MEASURES:
Pressure
•
Use 5/16” or 8mm Allen wrench
to
adjust the roller pressure:
Clockwise – Increase pressure.
Counter Clockwise – Decrease pressure.
1. Using Push-Pull Scale
, measure
Figure 1
Clockwise
Counterclockwise
Figure A
Figure B
Figure C
Decrease
Increase
Figure 2
13
