RIM-HD-13SS
9
USING YOUR ICE MAKER
Operation panel and display
1. Plug in to the power supply outlet. Press “ON/OFF” button on the control panel to begin the ice making cycle.
2. When you plug in the unit, the power symbol< > will flash. Press the <ON/OFF>button to start making ice cubes. The ice making
symbol< > will display. The left upper corner of display area will show the ambient temp., i.e. 80
℉
. After several minutes, this area
will show a flashing ice making countdown number, i.e.10M which means the ice making will finish 10 mins later.
3. When ice making symbol< > flashes, the water will flow from top water reservoir to the bottom water tank The symbol < > will
be on when the water in the bottom water tank is full new line/paragraph. The symbol < > will be off and then
the next ice making cycle starts again. When there is no water in the water reservoir, the symbol < > will stay on. Turn off the unit
and fill water again, and then restart the unit to make ice cubes. Alternatively, fill water directly and wait 20 minutes and the unit will restart
Note:
The ice making cycle lasts about 13 to 25 minutes, depending on the ambient temperature.The first time this machine makes ice,
the time to make ice may be a little longer than normal. If the room where the ice machine is located is hot/humid, the ice time
may also increase
Note:
To increase or decrease the thickness of the ice, press the<+>and<->to set the ice making lead time. Press one time and
the ice making cycle will increase or reduce one minute to 6 minutes maximum. This will only start from the new ice cycle.
4. When Ice Full symbol< >is on, the unit will stop. Remove ice cubes to have the unit begin making ice again. If you press the
button<ON/OFF>more than 5 seconds when the ice maker is working, the unit will start making ice. Press button<ON/OFF>, and the
unit will turn off.
STEP1: Qucik connector and the water faucet
STEP2: Screw the qucik connector on the water faucet by the screw thread, and remove the clip
STEP3: Insert the water hose completely
STEP4: Install back the clip
Remove the
clip first
Push invards
