3. Wall panels
Position two plain panels on the corner of the floor as shown. Note how the panel frames sit on the floor with the panel cladding overhanging the floor edge. Ensure square,
secure the two panels together using 3 x 50mm screws. Screw through the frame of the side wall panel into the frame of the back wall panel. Place a third plain panel along
the back wall, push it up against the other panel and with the two panels level secure together using 3 x 50mm screws through the frame of the first panel into the frame of
the second. Continue adding the rest of the panels following the diagrams below.
Front panels
Back wall
Side wall
2. Fitting the windows
Lay the window panel on the floor. Fit two hinges in the rebates on the top of the window as shown in the diagram using 2 x 25mm screws per hinge, stand the hinge end
of the window on the window panel, making sure it is centred at the top of the window opening. Open the hinges and secure them to the window frame using 3 x 25mm
screws per hinge. On the inside of the window panel fit the window stay and its two posts using 6 x 25mm screws as shown in the diagram.
25mm
25mm
25mm
View from inside
of window
1. Floor
Prepare a level area for the summerhouse to sit. Attach three wooden or similar bearers of size 50 x 50 x 2050mm to each of the floor sections (not supplied in kit). Place the
two sections in position butted up next to each other. Attach four wooden or similar bearers of size 50 x 50 x 840mm to the verandah floor.
Panel frames
rest on floor.
Panel cladding
overhangs floor
edge.
50mm
Back wall
Side wall
It is recommended to drill pilot
holes for these screws with a 2mm
drill bit before assembly.
50mm
Drill
Use this diagram to check the
correct orientation of the
corners
Important note
To
"VALIDATE"
the guarantee, adequate provision must be made to ensure ground
contact is avoided and air is able to circulate underneath the building.
Placing the building on a concrete pad or slab base is acceptable provided that the
building is not allowed to sit in pooled water during wet conditions.
If the building is to sit on soil or grass it
MUST
be erected on pressure treated
wooden 50mm x 50mm or similar bearers
(These are not supplied in the kit).
Rowlinson Garden Products recommend using pressure treated bearers with all build-
ings on any type of base.
When laying the floor, it is
important to note the T&G floor
boards must run from the front
of the building to the back.
Important
Important
Side wall
