Rowe BC-1200, Field Service Manual And Parts Catalog

Page: 68 / 217

Section 3: Routine Service
25238802 3-17
Figure 3-13. Bill Stop
Flipper Adjustment
Adjusting the Bill Stop Flipper
Refer to Figure 3-13 while you are doing this procedure.
1. The position of the bill stop flipper (A), can be adjusted
by prying against the solenoid plunger stop tab (B)
through the flipper opening in the pusher plate with a
screwdriver (Service tip: Pry up on the stop tab
(B) to
lower the flipper; pry down on the stop tab to raise the
flipper).
Installing a New or Replacement Bill Stacker
BC-1200 ONLY
Refer to Figure 3-14 and adjust the lower bill box stop bracket and mounting plate so that the bottom bill box is
aligned with the upper bill box and chute guides in the following manner:
1. Perform the bill transport-to-stacker alignment procedure as described earlier in this section.
2. Adjust the lower bill box stop bracket and mounting plate so that the stacker hangs straight up and down by:
A. Loosening the two 8-32 screws (A) holding the mounting plate to the changer bottom panel.
B. Loosening the two screws (C) holding the mounting plate (B) .
C. Moving the mounting plate around until proper alignment is obtained.
D. Tightening all four screws.
3. Refer to Figure 3-14 and make sure that the bill boxes (D) are tight against the chute guides (E) to get proper
stacking.
4. Refer to Figure 3-14 and loosen the two #8-32 screws (F) in the lower bill box stop bracket . Push the lower
box tight against the chute guides. Push the lower bill box stop bracket tight against the bill box and tighten
the two #8-32 screws.
B A