Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
(800) 658-5925
Page 2 of 3 for Gate Assembly
3.) If your needs require the gate to be left-hand opening, un-snap the #RGH Handle from the Roverpet PVC Panel, and
install it on the opposite side of the Panel. Note that for left-hand opening gates, the assembly procedure will be
reversed for the #RGC Clasp set installation that follows. (See diagram on next page)
4.) The #450 Wall Clasps (2-1/4
” length) need to be secured to the wall on the
HINGED SIDE
of the gate. They need to be
aligned vertically along the doorway/hallway opening. The #450 Clasps should
be mounted 6” above the bottom of the
gate, and 6” below the top of the gate. Use the supplied hardware to mount the clasps to the wall using a #2 Phillips
screwdriver. Use a 1/8” drill bit if pilot holes are needed..
Please Don’t Over Tighten Supplies Screws
If your Roverpet Dog Gate was supplied with more than (2) #450 Clasps, the remaining #450 Clasps need to be
mounted between the top and bottom #450 Clasps that were just installed on the wall, verify the locations will not
interfere with the center bar of the Roverpet PVC Panel.
5.) Mount the #350 Wall Clasps (1-
1/8” length) in the same manner as in Step 4. Mount them on the opposite wall from the
installed #450 Clasps. The #350 Clasps are used on the
LATCH SIDE
only with the #RGH Handle.
6.) Remove the installed #250 Clips from the Rover Panels. Expand the panels to stretch between the mounted #450 and
#350 Clasps. Reinstall the #250 Clips to the top and bottom of the Roverpet PVC Panels. Snap the Roverpet Pet Gate
into the Wall Clasps. Make certain the
HINGED SIDE
of your gate is secured in the #450 Clasps.
Congratulations, you are now ready to use your Roverpet Dog Gate!
Note:
With a new Roverpet Dog Gate installed, the Wall Clasps can seem excessively tight or noisy.
A thin coat of Vaseline on the inside of the Wall Clasps can greatly assist with these issues
.
Assembly for ‘V’ Shape Mounting
(See Figure 2)
3.) If your needs require the gate to be left-hand opening, un-snap the #RGH Handle from the Roverpet PVC Panel, and
install it on the opposite side of the Panel. Note that for left-hand opening gates, the assembly procedure will be
reversed for the #RGC Clasp set installation that follows. (See diagram below)
4.) The #450 Wall Clasps (2-
1/4” length) need to be secured to the wall on the
HINGED SIDE
of the gate. They need to be
aligned vertically along the doorway/hallway opening. The #450 Clasps should be mounted 6” above the bottom of the
gate, and 6” below the top of the gate.
