Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
(800) 658-5925
Page 3 of 3 for Gate Assembly
If your Roverpet Dog Gate was supplied with more than (2) #450 Clasps, the remaining #450 Clasps need to be
mounted between the top and bottom #450 Clasps that were just installed on the wall, verify the locations will not
interfere with the center bar of the Roverpet PVC Panel.
5.) Mount the #350 Wall Clasps (1-
1/8” length) in the same manner as in Step 4. Mount them on the opposite wall from the
installed #450 Clasps. The #350 Clasps are used on the
LATCH SIDE
only with the #RGH Handle.
6.) Remove the installed #250 Clips from the Roverpet PVC Panels. Snap one side of a Roverpet PVC Panel into the #450
hinge clasps. Make certain the
HINGED SIDE
of your gate is secured in the #450 Clasps. Snap the side of the second
Roverpet PVC Panel with the #RGH Handle into the #350 latch clasps. Install the #250 Clips to connect the Roverpet
PVC Panels together
where they meet in the ‘V’ Shape.
Congratulations, you are now ready to use your Roverpet Dog Gate!
Note:
With a new Roverpet Dog Gate installed, the Wall Clasps can seem excessively tight or noisy. A thin coat of
Vaseline
on
the inside of the Wall Clasps can greatly assist with these issues.
Property of Roverpet
