Rover 75 Saloon, Owner'S Handbook Manual

Page: 48 / 285

48
Parking Heater
Setting the current time
NOTE: Both the current time and any preset start-up time are set and
displayed in 24 hour clock format.
If the power supply to the unit has been interrupted (by vehicle
battery disconnection, for example), the time of day will need to
be reset and any preset programmes will be lost. Reset the time as
follows:
•
Press the clock control (3) - the display illuminates and the
clock symbol and ‘:’ flash.
•
Set the time using the timer adjustment controls (5), pressing
the right control to advance the time and the left control to turn
the clock back. The time increments in minutes, with the
incremental change accelerating the longer the control is kept
depressed.
•
Once the correct time is displayed, release the control and leave
the unit for approximately 10 seconds, until the display
extinguishes.
NOTE: To display the current time, press the clock control. The display
illumination ceases 10 seconds after the control is released.
Setting the heater start time presets
Up to three different preset start times can be programmed using
the timer unit, as follows:
•
Press the ‘SET’ control (4) in the timer unit - the display
illuminates, showing a preset programme number (on the right
hand side of the display) and previously programmed start time
associated with that preset.
•
If the desired preset is not displayed, press and release the ‘SET’
control again. This cycles through the presets - repeat until the
desired preset number is displayed.
•
To adjust the start time for that preset, use the timer adjustment
controls (5) to set the desired time.
NOTE: You must begin to set the start time within approximately 10
seconds of selecting the desired preset (before the display illumination
ceases), otherwise the above procedure must be repeated.
If at any time you wish to cancel the programming process, press
and release the ‘SET’ control repeatedly (cycling through the
preset numbers) until the display and preset number extinguish.
Selecting a preset programme
Press and release the ‘SET’ control (4) repeatedly until the desired
preset number is displayed (‘1’, ‘2’ or ‘3’) and check that the start
time is correct. After 10 seconds, the start time will extinguish, but
the display remains illuminated. The timer is now set to activate
the heater at the programmed time.
To cancel a programmed preset start-up time, press and release the
‘SET’ control repeatedly (cycling through the preset numbers)
until the display extinguishes.