Hardwire Kit not powering the dash camera
Make sure that the taps' fuse slots are connected
to have at least 10A to 30A.
Flip the fuse taps 180 degrees and re-connect them
to the fuse slot/s.
Please try other slots on the fuse box that is for
con�nuous power and ACC slots.
Check if the parking mode switch is switched over
to the le� and make sure the voltage cut off switch
is set to the lowest se�ng of 11.8V for the tes�ng
purpose. (You can adjust this later)
Lastly, if it s�ll doesn’t power on with the above
steps, then you should make sure your car’s ba�ery is
fully charged. The car’s ba�ery’s voltage should read
higher than the voltage cut-off se�ng; otherwise,
the HWK will not provide power to the dash cam.
This might be the reason your dash cam is not ge�ng
power. You should also go to page 19 and do the full
step of tes�ng the Yellow and Red Add-a-fuse to
make sure you have voltage coming through.
Make sure that old fuse is plugged into piggy back
fuse cable and all fuse cables are connected to the
fuse box and on the correct spot.
RED
WIRE should be tapped into a fuse slot that
supplies constant power.
YELLOW
WIRE should be tapped on an ACC fuse slot.
BLACK
WIRE, which is the ground wire. It should
be securely bolted on a metal ground connec�on.
TROUBLESHOOTING YOUR ROVE R2-4K
ULTIMATE 3-LEAD HARDWIRE KIT - MINI-USB
•
•
•
25
Mini-USB
Mini-USB
