Rovan LT-4WD, Instruction Manual

Page: 9 / 30

9
1. Set all trims(and sub-trims if included)on
your transmitter to “0”or neutral(half way
between end points).
2. Remove the cover of the radio box and
note that the bind plug is installed into
the first port marked “BINE/RS” of the
receiver.
3. Turn on the power-a light will flash at the
right front corner of the receiver.
4. Turn on your transmitter and follow the
instructions in your transmitter manual for
binding.
5. When the light in the receiver stops
blinking and is on solid, the radio is
bound.
6. Turn off the power, remove the bind plug,
and reinstall the radio box cover.
These are starting points for your transmitter. You may have to adjust the “Trim” and “Sub-Trim” as
noted in the radio manual to set the neutral position of the linkages. Transmitters without sub-trim
may require mechanical adjustment to the linkages.
• When binding, follow the failsafe instructions of
your specific transmitter so that the throttle will
be reduced if the signal is lost.
• Always remove the bind plug from the receiver
after binding is complete.
• Never plug receiver battery packs into
telemetry ports marked RPM,TEMP,or LAP.
This will damage the receiver.
• Make sure the antenna plug in the antenna
tube fully.
• It is necessary to rebind when different failsafe
positions are desired or when throttle or
steering reversing has been changed.
Transmitter Setup
Caution
The Binding Process
Installation Guide
SECTION B