13
VARIETY STEAMER (VS-250)
P/N 1010998 Rev. C 11/12
4. Lift and slide the Locking Lever (Figure 8)
towards the rear, and then carefully remove the
Black Manifold Plate. Then remove the large
black O-ring from the plate.
5. Remove the Diffuser Plate. Then remove the
Spray Tube by carefully lifting the loose end and
gently twisting and pulling it out of the Steam
Generator hole.
6. Take a suitable 1/16” punching tool (such as a
paperclip) and insert it through all 18 orifices
in the Black Manifold and the 10 orifices in
the Spray Tube to assure the orifices are not
obstructed with debris. Wash all items in hot,
soapy water, rinse, and then allow to air dry.
7. Reinstall the Spray Tube into the Steam
Generator hole and reinstall the Diffuser Plate.
8. Lightly apply some Petrol Gel (included) onto the
O-ring and reinstall the O-ring onto the Manifold
Plate (this allows the Manifold Plate to seat easily
onto the Steam Generator).
9. Hold the Manifold Plate up to a light source and
verify that light is visible through all the orifices. If
so, seat the manifold fully onto the Generator and
pull the Locking Lever forward to lock the plate.
10. Check that the Water Pressure Regulator is
correctly set to 20 psi (1.4 kg/cm2 or 138 kPa).
11. Reinstall all parts and accessories.
MAINTENANCE
Daily Cleaning
NOTE: Frequency of cleaning is determined by
water conditions, usage, and water filter systems.
1. Turn the power off, unplug the power cord, and
allow the unit to cool for 30 minutes.
2. Check the rear water quick disconnect fitting and
all hose clamp connections for leakage. If leak-
age is apparent, tighten all clamps or replace
part(s) if required.
3. Remove the Baskets, Top Cover Assembly, and
Drip Tray (Figure 8). Wash in hot, soapy water,
then rinse and allow them to air dry.
CAUTION
Do NOT use a sanitizing solution or abrasive
materials. The use of these may cause damage to
the stainless steel finish.
CAUTION
Failure to regularly and/or properly clean this
equipment may damage it or cause the user
bodily injury.
WARNING
Refer to the instructions for cleaning and handling
the unit within the Important Safety Information
section of this manual.
Figure 8. Steamer Components & Accessories
O-ring
Diffuser
Spray Tube
Black Manifold
Plate
Drip Tray
Lock
Lever
Top Cover Assy.
Double
Baskets
Steam
Generator
Black
Drain
Tubing
Inlet Hose Assy.
(w/ Strainer)
Hi-Limit Thermostat
(inside unit)
Electrical
Housing
Cover
Pressure Relief
Plunger Assy.