ROUND Pools V35027, Installation Manual

Page: 17 / 37

2-1 No Diving or Jumping. Observe all Safety Rules
1. Lay out bottom plates
a. Place the bottom plates equally spaced around the
perimeter of your foundation. If you are using the
optional patio stones, depending on your model
place one bottom plate on each stone.
(Image 1)
2. Assemble bottom plates and bottom rails
a. Insert the end of each bottom rail into a bottom
plate. Leave a gap between the ends of the bottom
rails.
(Images 2-3 )
b. Measure the diameter of your pool all around the
circle and make sure it is correct.
Note: this measurement should be taken from cen-
tre to centre of the bottom plate. When the circum-
ference is perfectly round, hammer nails into the
ground to keep the bottom rails into place.
These nails are to be removed only at the last step-
when filling up the pool.
A. LAY OUT THE BOTTOM PLATES AND BOTTOM RAILS
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL BASE
Section
2
1
Important Note:
Use a soft measuring tape to measure around the
perimeter of the pool. Measure from the inside of the
bottom rail, the measurement should equal the wall
length.
2
See Diagram:
Please refer to your pool’s footprint (Section 1) for gap
measurement.
3