1.
Removal of the factory steps or the plugs covering the nutsert at the step mounting location are required before
installation of the Rough Country Steps. Retain the factory hardware to install the brackets to the body if desired.
2.
Remove the plugs in the nutserts at the step mounting location.
See Photo 1.
3.
Locate the driver side front mounting bracket.
See Photo 2.
4.
Install the supplied 8mm nut plate onto the back side of the step.
See Photo 3.
5.
Install the front mounting bracket onto the front side of the step using the supplied 8mm
-
1.25mm x 25mm hex head
bolt, 8mm Lock washer and 8mm flat washer into the nut plate.
Do Not Tighten. See Photo 4.
6.
Locate the driver side mid and rear mounting brackets.
See Photo 5.
7.
Install the mid and rear mounting brackets onto the step using the nut plate and supplied 8mm
-
1.25mm x 25mm hex
head bolt, 8mm Lock washer and 8mm flat washer into the nut plate.
See Photo 6.
Photo 1
Photo 2
Photo 3
Photo 4
Photo 5
Photo 6
Remove the plug from the nutsert.
Driver side front mounting bracket.
Install the nut plate.
Install the mounting bracket onto step.
Drivers side Mid and Rear mounting brackets.
Install the mid and rear mounting brackets.
INSTALLATION INSTRUCTONS
Front.
Front.
