Rottler SG7, Operation And Maintenance Manual, Page: 52 / 102

Section 6 Maintenance SG7 Manual
www.rottlermfg.com
6-1
Maintenance
Quick Reference Lubrication Chart
Refer to the maintenance section in the manual for lubrication location points and instruction.
Assembly Frequency Lube Operation R e c o m m e n d e d
Lubricant
Date Serviced
Outer Spindle 8 Hours Clean and Wipe with
oil
ISO VG 68 Way Oil
Brass guide
shoes/slide
500 Hours Clean and wipe with
oil
ISO VG 68 Way Oil
Grease spindle
Rack and pinion
500 Hours Clean and grease NLGI #2 White
Lithium Grease
Grease spindle
worm wheel and
worm shaft
500 Hours Clean and grease NLGI #2 White
Lithium Grease
Grease spindle
drive shaft
500 Hours Clean and grease NLGI #2 White
Lithium Grease
Grease rollover
clamp fixture
bearings
200 Hours Clean and grease NLGI #2 White
Lithium Grease
Grease clamp
fixture Pins and
Acme screw
200 Hours Clean and grease NLGI #2 White
Lithium Grease
Preventative Maintenance Quick Reference Chart
Refer to the procedures in the maintenance section of the manual to make or check these adjustments.
Not all of the items listed in the table below have adjustment. The information should be recorded and the
amount of wear tracked so the part can be replaced before down time on the machine occurs.
Procedure Frequency Date Serviced/Comments
Clean top and bottom float tables 8 Hours
Outer Spindle Bushing Adjustment 500 Hours
Brass Shoe Adjustment 500 Hours
Angle sensor calibration 500 Hours
Spindle Drive Belt Adjustment 1000 Hours
Adjust workhead clamp plate bearings 1000 Hours
Rack and pinion adjustment. 1000 Hours
Machine Level Adjustment 1000 Hours