Doc. No.: ORM0051_1 Page
15
of
22
2.2.2 Diagnostics
–
Test Results
Selecting “Test Results” in the diagnostics screen will display
the following screen.
This screen displays the three results that can be stored on
the controller:
Current
–
the last diagnostic test completed
Master
–
the diagnostic test completed when the
controller was first installed
FAT
–
the diagnostic test completed during the Factory
Acceptance Test
When selected the following screen displays the available
options for each test result.
Result Type (read-only)
The name of the diagnostic result being viewed.
Date (read-only)
Date that the diagnostic test was started.
Time (read-only)
Time that the diagnostic test was started.
Result (read-only)
Whether the diagnostic test passed or failed.
Failure Code (read-only)
The code indicating the reason why the test failed. A value
of zero is shown if the test passed, a value of 254 is shown if
the test was manually aborted, and any other value
indicates the measurement number which caused the test
to fail.
Graph
When this option is selected the raw data recorded during
the test is displayed.
The following screen displays an example of recorded graph
data.
Measurements
When this option is selected the measurements recorded
during the test are displayed.
If the value is green it indicates that the measurement
finished and was within acceptance limits, if the value is red
it indicates that the measurement was outside of the
acceptance limits, and if the value is black it indicates that
the measurement did not complete (usually caused due to
the test being aborted).
The following screen displays and example of recorded
measurements during a diagnostic test.
