©Roto VR is a UK Ltd company. Companies House: 9473421. VAT Reg: 241423444.
28 Church Road, Stanmore, Middlesex, HA7 4XR, United Kingdom www.rotovr.com
5
Quick tip before you carry on! We would recommend putting the headtracker on charge at
the mains by using cable N now so that it can charge while you are setting the rest of the
chair up. You can find the cable in box 4 (small brown box inside box 1).
Main PCB Installation
We do have a handy little installation guide, which can be seen
, but should you wish
for a little extra help, keep on reading!
Step 1
•
Remove the PCB from Box 4 (Box 4 is included in Box 1
–
it is a small brown box)
Step 2
•
Installation
1)
Turn the base fully upside down
2)
Unscrew the U-shaped bracket from the base
–
this has Philips screws on, so a
matching screwdriver will be required.
3)
Slide the PCB in next to the current box
–
they both have a ridge on them for the
bracket, so make sure that these are the right way round
(you’ll want the ridges
facing up towards you).
4)
Plug the cables from the cable magazine into the back of the PCB
5)
Line the two boxes up, ensuring the ridge mentioned before is aligned, and screw
the U-shaped bracket back into place.
The PCB does
sit back a bit further than the edge of the base, so don’t worry if the
y look like
they are pushed inwards.
